- 3. Straightening and cutting: straighten and cut the cold galvanized wire after drying to reach the set size and length.
Post time: 02-06-22- Plastic spraying is also known as electrostatic powder spraying. It is the use of electrostatic attack device to make plastic powder charged, adsorbed on the surface of the iron plate, and then through the baking of 180~220℃, so that the powder can be melted and adhered to the metal surface. Plastic spraying products are mostly used in the indoor box, and the paint film appears flat or matte. Spray powder mainly acrylic powder, polyester powder and so on.
2, hot plating wire plating after processing
- But there are some necessary precautions in the production of galvanized wire. Remove all tools and piles on the work site and equipment that hinder activities, and slowly put the wire into the cylinder during pickling to prevent acid splashing on the body. When adding acid, the acid must be slowly poured into the water. Do not pour water into the acid to prevent acid spillage and injury. Workers should wear protective glasses when working. Then in the handling of wire and other items, it is strictly prohibited to push hard.
When using these two products, it is obvious that there is a gap between them. By pulling or bending the wire, it is often difficult to restore the original, for example, if the same place is repeatedly bent, it will be found that it has broken, and the cold drawing wire will not. Cold drawing wire compared with iron wire, its hardness, tensile resistance, bending ability is greatly enhanced, suitable for building materials.
The barbed wire factory will store the blade barbed wire inventory in the appropriate place, because it understands the product characteristics.
- The spring operating at high temperature requires that it can adhere to the elastic limit and good creep resistance at high temperature. In addition, the forming process and heat treatment process of spring steel wire should also be considered. Cold drawn spring steel wire and oil quenched tempered spring steel wire are directly around the supply of steel wire spring, spring forming after the elimination of stress directly used.
- 4, the material requirements of silk: wire drawing weaving, electric galvanized wire weaving, hot galvanized wire weaving, first woven after hot plating.
6, according to the wire diameter thickness to adjust zinc dipping time. Zinc dipping time should be adjusted according to the thickness of wire diameter. The method of adjustment is the length of the distance between the lead screw on the zinc pot and the ceramic sinking roll. The zinc dipping time of coarse wire diameter should be long, and the zinc dipping time of fine wire diameter should be short.
- In the calculation process of 12*14 specifications of barbed rope, it can not be calculated according to the above calculation formula, because first of all, two specifications of raw materials are used, the thinner the wire diameter, the higher the processing cost. Generally speaking, a kilogram of 12*14 barbed rope can reach about 7.5 meters, and the ratio of warp wire to barbed rope cannot be calculated according to the traditional ratio of 7 to 3. The exact amount of stinging and use the warp need to increase after a series of professional measurement on the loss of raw materials and so on factors to calculate.
Cold galvanized, generally speaking, do not need heating, galvanized amount is little, this galvanized parts are easy to fall off in wet environment. Hot dip galvanizing, also known as hot dip galvanizing, is to melt the zinc ingot at high temperature, put some auxiliary materials in, and then dip the metal structural parts into the galvanized groove, so that the metal members are attached to a layer of zinc layer. The advantage of hot dip galvanized is that its anticorrosion ability is strong, the adhesion and hardness of galvanized layer is better.
- The surface of alluvium before hot dip galvanizing of orchard special electric galvanized shaft wire can partially remove the surface film layer, surface impurity and other shortcomings according to the basic technology to find and solve; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. There are many fine homogeneous particles in the tank, can stabilize the foam layer, with activated carbon mat to remove surface active substances. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to reduce the amount of surface-active substances introduced. The introduction of organic matter can make the electroplating process speed drop sharply. Although the secret recipe of organic chemistry is beneficial to the high accumulation rate, the thickness of the coating can not meet the requirements after the organic matter is brought in, so the activated carbon can be used to solve the tank.
- Welding net material has black wire, galvanized wire, wire drawing. Mesh has 1 inch, 2/1 inch, 3/1 inch, 4/1 inch, 4/3 inch, 8/5 inch, etc. Different materials, different mesh, used in different places. Therefore, welding net is an indispensable building material in construction industry.
Post time: 07-04-23- Three is to do a good job of galvanized silk product production site clean and tidy, in accordance with the scientific method of operation to operate the production, the operator should wear the required dress. If it is hot dip galvanized wire products, we must do a good job of passivation treatment, will be able to effectively prevent discoloration, prolong the method of discoloration, can solve the problem of discoloration.
Post time: 19-09-22- The cage can be placed in a corner so that the bird can see what is going on around it and can retreat to the back of the cage without fear of being approached. The height of the cage from the ground is also important and is ideal slightly below eye level.
- 3, whether positive and negative twist, whether the need for bilateral silk.
- The mesh size of the wire mesh specification, as well as the diameter and thickness requirements, are limited to the amount of steel and galvanized per square meter. Mainly in order to consider the corrosion resistance, prolong the service life, and in the use of the process of safety.
1. After getting the bird cage, do not rush to use it. Clean the cage with a clean cloth or rubber. Then use fine yarn paper (do not use coarse sandpaper randomly), gently polish some parts that need to be polished again to improve the surface finish and trace, and pay attention to not damage the original bamboo green. After careful observation, use a razor blade to carefully clean the individual areas with small burrs.
- For example, if the barbed rope is used to circle, the cost per meter is only a few yuan, if the ring with other products, it may be more than ten yuan or even 20 yuan, which undoubtedly increases the cost of the user again, so the cattle and sheep with barbed rope is the most economical product