...
2025-08-15 07:44
2642
...
2025-08-15 07:39
1294
...
2025-08-15 07:09
2005
...
2025-08-15 06:37
1492
...
2025-08-15 06:17
1548
...
2025-08-15 06:17
965
...
2025-08-15 06:08
620
...
2025-08-15 06:04
1655
...
2025-08-15 05:39
1764
...
2025-08-15 05:29
2242
a) The shaft on which the oil seal is to be mounted should be ground with the surface finish or surface roughness between 0.2 to 0.8 Microns. It is best for the shaft to be hardened atleast to 40 – 45 HRc in order to prevent groove formation on the shaft due to the pressure exerted by the spring.
- The Dual Spark Plug Revolutionizing the Future of Energy
- In modern vehicles, spark plug wires have been replaced by direct ignition systems, which eliminate the need for a distributor
- substituted for silicone rubber and adhesive.
PTFE oil seals