- b. Polyacrylate Rubber (PA) – also known as acrylic rubber, this material has better heat resistance than nitrile. PA is also recommended for a high surface speed environment. Operation temperatures are recommended from -4 to 302⁰ F (-20 to 150⁰ C). Polyacrylate rubber should not be used with water or in temperature below -4⁰ F (20⁰ C).
- One of the main benefits of using iridium spark plugs is their longevity. Iridium is one of the most durable materials used in spark plug construction, allowing these plugs to last much longer than traditional copper or platinum plugs. This means you won't have to replace them as often, saving you time and money in the long run.
- Introduction
- .
An oil seal, also known as crankshaft retainer, is a small device, but essential to ensure the proper engine operation. It plays a key role in all moving parts of an engine, acting as a physical barrier. This mechanical seal fulfils the dual purpose of sealing a rotary shaft to maintain the necessary lubrication (avoiding leaks) and preventing other foreign matter from contaminating shafts and bearings in the rotary shaft equipment.
- Single lip oil seal
Sealing property Sealing edge This refers to the component of the oil seal that makes contact with the shaft.
It is wedge-shaped to be pressed against the shaft surface and makes contact with the shaft to ensure sufficient sealing performance and suitability for operation at high peripheral speed.Oil Seals Enable Your Equipment to Operate Efficiently
Usually, these oil seals are used to seal lubricating oil or grease and contain it within the application, so that moving parts such as bearings are continually supplied with enough lubrication. However, such seals are also used for sealing other liquids, gases, and solids, such as powders or granules.

m20 valve cover gasket. Once the cover is removed, the old gasket can be easily peeled off and replaced with a new one.
Rotary shaft or oil seals are placed between moving and stationary pieces of machinery to ensure that contaminants, moisture, corrosive materials and abrasives do not damage the various components. They can also prevent unwanted mixing of fluids, including water and oil combining within a machine.
To install an oil seal properly, the shaft must be undamaged. This is so the oil seal can do its job properly on the one hand, and to prevent it from being damaged during fitting on the other. In addition, it is very important to lubricate the shaft, the sealing lip and the bore with plenty of grease. This will allow the oil seal to slide more easily over the shaft and prevent dry running after the first rotation. The oil seal may also come into contact with the keyway, thread or other grooves when sliding over the shaft. By taping or covering the shaft at the location of these irregularities with oil-soaked paper, the oil seal can be mounted without damage to the sealing lip.

synthetic rubber gasket.
Case study 2: Silicone oil leakage
inside the engine.
WHICH MATERIALS MAKE UP SEALS?
Even the slightest chip or dent can cause contaminants to infiltrate your oil seal. If there are any scratches on the shaft, a leak path may develop, allowing the lubricant to drip. To protect the shaft from damage, wrap it in a mesh rubber screen and store it vertically in its compartment. This way, it can be shielded from potential cracking.
Various materials with unique properties are utilised in the construction of rotary shaft seals, allowing manufacturers to tailor the sealing solution to specific industry requirements and ensure optimal performance.
Runout
Oil seals, also known as shaft seals, are radial lip type seals which are primarily used for retaining lubricants in equipment having rotating, reciprocating or oscillating shafts. The rotating shaft application is most common.