Viton Oil Seals - A synthetic rubber and fluoropolymer elastomer, Viton is used to make oil seals that provide resistance in both high temperature, up to 250°C and low compression set components. They also offer a high resistance to chemicals and abrasions, so they can be used in elements that regularly interact with petroleum and solvents.

Start the engine and check for oil leaks.

The major cause of extrusion and nibbling is stress caused by high pressure. This is commonly noticed when the oil seal has a chipped or nibbled look. In fact, in some cases, the surface of the seal tends to peel on its own, which makes it have a shaved look. What the stress does is that it increases the clearance gap between the mating edges, which causes the seal to get entrapped, and then leads to severe physical damage.

What are oil seals?

Broad chemical resistance, except against liquid alkaline metals and fluorine gas under pressure. Good sliding qualities, low wear and tear. Temperature range from -200 °C to +260°C. PTFE has hardness of approximately 95 °Shore and installing these O-rings in split grooves is recommended or alternatively the use slit or sheathed types due to the low elasticity.

Silicone 

a) The shaft on which the oil seal is to be mounted should be ground with the surface finish or surface roughness between 0.2 to 0.8 Microns. It is best for the shaft to be hardened atleast to 40 – 45 HRc in order to prevent groove formation on the shaft due to the pressure exerted by the spring.

Bauerle and Bruhnke⁷ found that aeration reduces the effect of oil additives on fluoroelastomer properties. Some of their data is reproduced in Fig. 14.4,⁵ showing the effect of aeration of an SF-grade 5W30 oil on the retention of elongation of a VDF/HFP copolymer (FKM-E430), a VDF/HFP/TFE terpolymer (FKM-B600), and a VDF/PMVE/TFE fluoroelastomer (FKM-GFLT). The HFP-containing polymers show much better retention of properties with aeration.

What are oil seals?

1) Oil seals for cars

• ACM rubber or another

⑥