Engine Oil Seal:

Table 2 a): Common types of oil seals (with spring)

ERIKS type GV (type C according to DIN) is equivalent to type M, but is a heavy-duty version with a double metal casing. This can be a useful solution with larger diameters in more demanding applications. There is also a version of this type with a dust lip; the GVST (type CS according to DIN).

Also known as a Rotary Shaft Seal, Shaft Seal, Lip Seal, Elastomeric Lip Seal or any variation of these. It is a simple device for excluding dust, dirt, water or any other contaminant whilst retaining lubricant in rotary shaft equipment. Generally, it has been developed as a means of protecting the bearings of rotating shafts.

Oil seals keep contaminants separate from the lubricants that keep rotating shafts and precision bearings in good working order. Oil seals are also known as rotary shaft seals, lip seals, and shaft seals.

EPDM oil seals are less common. They are used in solvent, hot water and steam applications, EPDM resists low temperatures down to -50 °C and UV radiation well. Some types of EPDM are also suitable for higher temperatures up to +150 °C. EPDM oil seals are usually available upon request.

These are comparable to type R and RST, except the outer case does not have a metal reinforcement ring. To compensate, the outside is not made of normal rubber, but a hard, heavy-duty rubber fabric. The advantage is that these types can be made in a split version. They are almost always produced to order, and made of NBR or FKM.

One way to recognize an improperly installed seal is by checking whether or not there is uneven shearing of the rubber after use. If this is evident, adjust by aligning the installation tools properly before pressing the seal into place.

Acrylonitrile-buta-diene natural rubber (NBR - Nitrile)

The care taken during the installation process will pay off by allowing the seal to work quietly and operate efficiently behind the scenes of your application.