Post time: 01-07-22- In what aspects is the uniformity of galvanized wire reflected:
- The two spines are 7 to 8 circles in the middle, while the ordinary spines are only 3 and a half circles, showing neat and beautiful. Now domestic customers see the positive and negative twisting rope, the impression is that the silk is too thin, can not play a protective role, in fact, it is not.
- Hot-dip galvanized hexagonal net is another way of twisting hexagonal net corresponding to galvanizing.
- C, coating uniformity: galvanized layer is basically uniform with copper sulfate solution test etched five times without exposing iron.
- When choosing a dog cage, we should pay attention to its material. Generally speaking, it is mainly composed of four materials, plastic, wire, square tube and stainless steel.
The barbed rope factory will store the blade barbed rope in a suitable place when it is stored, because it understands the product characteristics.
- Of course, the quality of any kind of product is also affected by the implementation of the specification by the manufacturer. If the manufacturer of electric welding mesh has no high implementation specification in the production itself, or the procedure specification has declined in the production line, or there is no higher requirement on the production link.
2, hot plating wire plating after processing
- Fruit green and grass green plastic-coated barbed rope can be said to be the special purpose of the highway, the rest of the use is relatively small.
- The small homogeneous particles with large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles will cause explosion. Coating with activated carbon to remove surfactant, or filtering to make the foam less stable, are effective measures. Other measures should also be taken to reduce the amount of surfactant brought in to Z. The speed of electroplating can be significantly reduced by the addition of organic matter. Although the chemical formulation is conducive to high deposition rate, but the organic matter with the coating thickness can not meet the requirements, so activated carbon can be used to treat the tank liquid.
Post time: 31-03-23- During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
Dogs of all ages seem to love to touch their noses with humans and other animals. In fact, dogs touch their noses as a way of socializing, just like humans shake hands and hug when they meet. But dogs don’t touch every human or every animal. They pick and choose who to touch. If they don’t like you or don’t know you at all, they won’t touch your nose. However, adult dogs will touch almost every puppy’s nose, and they will not only touch the puppy’s nose, but also smell it.
- Application scope of hot wire: Because the coating is thicker, hot galvanized has better protective performance than electric galvanized, so it is an important protective coating for steel parts used in harsh working conditions. Hot galvanized products in chemical equipment, petroleum processing, ocean exploration, metal structure, power transmission, shipbuilding and other industries have a wide range of applications, in the agricultural field such as pesticide irrigation, greenhouse and construction such as water and gas transmission, wire casing, scaffolding, bridge, highway guardrail and other aspects, in recent years has been widely used.
- The diameter of the wire is generally 0.3mm – 3mm, after the wire is not very strong, need to annealing, annealing this step is very important, can ensure the production of galvanized welding net, with good elasticity and toughness. After welding, the welding mesh becomes black wire welding mesh and can not be put on the market, because its corrosion resistance is poor and the service life is short, so it needs to be galvanized or dipped plastic treatment.
The production process of large coil galvanized wire is relatively simple. The wire after cleaning is put into electroplating solution first. Of course, the plating solution should contain zinc oxide, a direct current of steel, another zinc plate in the plating solution. The zinc is transferred to the surface of the steel as a molecule. If it shows a bright and beautiful color, the wire is coated with zinc.
Cold wire drawing is mainly used in the production of hardened low carbon steel wire, with a diameter of 8 mm steel bar to play a fixed role in the development of the construction industry has played a role in promoting the development of the construction industry, widely used. The bonding and anchorage performance between cold wire drawing and concrete is good. When used in components, the phenomenon of cracking in the anchorage area of components and damage caused by steel wire slip is fundamentally eliminated, and the bearing capacity and anti-cracking capacity of the end of components are improved.
Now the production of stainless steel blade barbed rope unless it is a specially customized model, under normal circumstances are the use of a knife length of 22mm mold production, that is, we usually say bto-22 type. It’s not necessarily the case that there are specifications from 11mm to 65mm. Unless the customer insists on customizing the required length, the barbed rope manufacturer produces bto-22 stainless steel blade barbed rope.
Post time: 24-03-23Annealing wire is widely used because it has a good elasticity and flexibility, in the annealing process can be good control of its hardness, it is mainly made of iron wire, more often used in the construction industry binding wire use. In the production of the wire factory, annealing wire will be processed according to the properties of the material, according to the needs of different to change its hardness degree, can make it has more advantages, can reduce the consumption of metal, reduce the cost of production.
- 4, barbed rope fence and culvert intersection, such as the ditch is narrow, barbed rope barbed rope fence can be directly across the ditch is wider, barbed rope barbed rope fence is difficult to cross, can take bridge, channel processing method.
Post time: 27-12-22- The reason for the bridge reinforcement is that the bridge durability function is poor and aging, through the steel wire mesh reinforcement, can prolong the service life of the bridge, to avoid the bridge cracks, collapse and other phenomena, steel wire mesh in the bridge reinforcement anti-crack engineering can play an obvious effect, improve the construction speed of the project, enhance the concrete anti-crack function, sum up the economic benefits.
Select cut silk first to ensure that the raw material of the silk is exactly the raw material you need, the raw material will be used well. Choose high straightness, so that the length of the truncation will be the same, will not show a lot of length difference, the length of the truncated wire is a very important element to choose the truncated wire.
Plastic-coated barbed rope is not only used but also beautiful, so it is used in a large number of highway sides, and other special places, so what are the colors of plastic-coated barbed rope? Where are the plastic-coated thorn ropes of no color respectively applied?
Post time: 30-03-23- The patented technology is used to regularly put zinc blocks into the plating aid pool, so that the bivalent iron in the plating aid becomes trivalent iron, and plays an important measure to stabilize the PH value within a numerical range, and also facilitate the filter to filter out the trivalent iron ions in the plating aid; The trivalent iron ion is controlled between 0.3 and 1.0g/L; When hydrogen is not released in the plating aid, the zinc block is continued. It is an effective measure to reduce zinc slag, improve the fluidity of zinc liquid and reduce the thickness of zinc layer to give full play to the function of plating aid filter.