Viton Oil Seals
• Quick response (centrifugal hydraulic pressure canceling mechanism) throughout the rotation range
(burr, corrosion, etc.), which will directly affect the service life of the oil seal.

Oil seals made of HNBR are characterised by excellent properties that include high resistance to mineral oils with additives, low steam and gas permeability, good cold flexibility down to -30 °C depending on type, good ozone resistance and friction resistance. HNBR seals withstand heat up to 150°C.
THE DIFFERENT SIZES OF OIL SEALS


From this kind of standard immersion testing, one would expect that bisphenol-cured VDF/HFP/TFE fluoroelastomers would not give good service life as oil seals. Similar tests with other elastomers, such as HNBR, silicone, and acrylic rubbers, show less loss of elongation. However, it is found that, in actual service, FKM shaft seals6 have much longer service life than seals of the other elastomers. In a Japanese study of FKM lip seals, rear crankshaft seals from high-mileage automobiles (70,000–280,000 mi ie, 110,000–450,000 km) were collected and examined. No serious oil leakage was found when the seals were removed from the engines. Some deposits were found around the seal lip and on the garter spring holding the lip against the shaft. No surface cracks were found on the seal lip, and only minor crazing on the crankcase side of the flexure portion of the seal in some samples. The seal compositions were not noted, but most were probably VDF/HFP/TFE elastomers with 68–69% fluorine content.

The oil seal manufacturing industry continues to witness innovations aimed at enhancing the performance and reliability of seals. Advancements in material science, seal design, and manufacturing processes have led to the development of seals with improved durability, resistance to extreme conditions, and enhanced sealing capabilities. These innovations contribute to the overall efficiency and longevity of machinery and equipment in diverse industrial sectors.

oil valve cover gasket. It is important to ensure that the gasket is installed correctly and that the valve cover is tightened to the manufacturer's specifications to prevent leaks.
