The first step in installing oil seals is to clean the surface where they will be placed. Dirt, debris, and other contaminants can cause the oil seal to become damaged or misshapen, leading to leaks. Clean the surface with a solvent or soap and water, and make sure it is completely dry before installing the oil seal.
(1) Shaft speed Due to design and structural reasons, high-speed shafts should use high-speed oil seals, low-speed shafts should use low-speed oil seals, and low-speed oil seals cannot be used on high-speed shafts, and vice versa.
2. Temperature: Just like pressure, it is very important to choose the right seal that can withstand extreme heat or cold temperatures, depending on the operating environment of your application.
Cold rolled carbon steel sheet
(JIS* SPCC)

DIN
The garter spring is located at the end of the primary sealing lip and used to apply pressure to the sealing lip against the shaft. Common garter spring material types are:

am5c spark plug. Over time, deposits can accumulate on the spark plug electrodes, which can inhibit the spark and reduce engine performance. The AM5C spark plug is engineered to resist fouling, ensuring that it maintains its performance and longevity.
Necessary to check compatibility with fluids
(See *2)
Oil Seal Installation


No.
B
