During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
- In the rolling process, if the surface of the steel wire is rough, the relative friction coefficient of the steel wire and roll increases, the friction resistance increases, the steel wire elongation decreases, the width increases. In the production of weighted leather material is easy to wide, is because of its rough surface. On the contrary, the surface of the steel wire is smooth, because the friction resistance between the steel wire and the roll is small, it is easy to extend, and the width is small. Domestic steel wire in order to prevent rust, the surface coated with butter, such as butter removal is not clean, easy to slip when rolled flat, also affect its width.
Paint on the galvanized layer, the binding force between each other and the baking temperature of the paint has a great relationship, after galvanized coating alkyd paint, adhesion is no problem. Galvanized amino paint, paint adhesion is not good. Do two bottom two surface, adhesion is ok, if the two bottom two surface to two bottom three surface, that is, more paint, more baking once, again test adhesion is very poor, poor to the paint from the galvanized layer of pieces torn off.
Post time: 28-11-22- Knitting mesh number: according to customer requirements
Most people in addition to pay attention to the price of barbed rope, many people for hot-dip galvanized barbed rope or cold galvanized barbed rope will have questions, in fact, these two products, the price difference is not very big, so how to choose hot-dip galvanized barbed rope and electric galvanized barbed rope?
The stainless steel barbed rope is made of stainless steel material after processing. The barbed rope has the characteristics of corrosion resistance and aging resistance. So why is the price of stainless steel barbed rope more expensive than ordinary barbed rope? Where do you want to go?
Hot – plated wire average performance: reflected in its cross – section, longitudinal uniformity. In the actual process of operation, such as steel wire jitter, the surface scum plating pot and other reasons will cause the surface of galvanized wire galvanized layer accumulation, should strive to solve the problem. In addition to these reasons, we should pay attention to the tooling and process must be stable, and regular testing should be done to ensure the uniformity of the galvanized layer.
For example, Przewalskopeles is a first-class protected animal in China. At present, as long as there are several other przewalskopeles populations around Qinghai Lake in China, according to incomplete statistics, there are only about 1,000 of them left. Stainless steel barbed wire fence net is commonly used in grassland pastoral area of Qinghai Lake, with a height of 1.5 meters.
- 3, a wide variety of specifications, a variety of shapes you choose, both European and American style and today’s popular fashion, full noble and modern beauty.
- It is recommended to have a brush, comb or rake ready before bathing your dog; Shampoo, conditioner, shower gloves, tether, bath mat, floor drain lid, spray, towel and shower shower.
- The effect of chemical composition and metallographic structure of steel wire
Remind you to buy galvanized iron wire, should be stored in dry, good ventilation conditions, do not contain corrosive gases, do not mix with the production of organic volatile gas paint, plastic and other substances in a good environment. If conditions, for galvanized parts to increase reliable inner packaging, and put desiccant. If the zinc layer white spots and hair, only mechanical removal, and then normal passivation, or thoroughly washed off the zinc layer after re-plating.
Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.
1, pasture installation of barbed rope material electric galvanized barbed rope and hot-dip galvanized barbed rope are economical choices. The products are durable and low in price.
The first is the cost of raw materials galvanized sheet and galvanized wire, some specifications and waste calculation and so on. Then there is the cost of mechanical processing process and manual processing process. Finally, there is the cost of packing and shipping. In recent years, due to the rapid development of thorn rope manufacturers, so the profit margin of blade thorn rope is not particularly broad.
When the barbed rope is used, it is calculated according to the length, while when purchasing the barbed rope, it is calculated according to the weight of the barbed rope, which causes the confusion of users’ difficulty in counting the quantity of purchase. Therefore, it is necessary to understand clearly that there are less meters per kilogram of the barbed rope. How much does a barbed rope weigh in a meter? These two problems, the purchase of barbed rope becomes very simple.
- The policy of wire mesh mesh size, wire, square meter steel content, galvanized amount, etc., to consider the corrosion resistance of wire mesh ability and system safety! Wire mesh galvanized is more fierce than the wire diameter, galvanized is very important, must be hot plating, welding after plating is better than the first plating after welding, as for wire diameter, inductive consideration of site construction and meet the needs of safety.
Compared with galvanizing, hot-dip galvanizing has lower production cost and less environmental impact than galvanizing. Because the coating obtained is thicker, hot-dip galvanizing has better protective performance than electric galvanizing, so it is an important protective coating for steel parts used in harsh working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, ocean exploration, metal structure, electric power transmission, shipbuilding and other industries.
Nestor rolling cage, high-speed railway Nestor rolling cage and railway Nestor rolling cage are all produced, sold and installed in accordance with the technical requirements of the reference drawing of railway line 2012-8001. Nestor rolling cage is a kind of protective equipment emerging in railway in recent years. Nestor rolling cage is connected by Nestor connecting clip on the longitudinal tensile rib fixed on the bracket. The longitudinal tension and the support are connected with the Φ2.5mm cold-drawn galvanized steel wire around 2 laps and then tightened. The support is set in the column and the middle of the span of the protective fence of 3m. The other spans are only set with the upper column, and the support and the protective fence are connected with the bracket hoop. For the protective fence that has been installed with metal mesh, the Nestor roller cage is directly fixed on the transverse sheet and wire of the metal mesh with the cold-drawn galvanized steel wire of 2.5mm or the Nestor connection fastener.
The distance between the adjacent two thorn rope installation do not know whether you have noticed? Careful observation can find that its spacing is not the same, the thorn rope factory for customer consultation when asking the installation height of the reason.
Hot dip galvanizing, also known as hot dip galvanizing, is a method of obtaining a metal covering layer by immersing a steel member into a molten zinc solution. With the rapid development of high-voltage power transmission, transportation and communication, the protection requirements for steel parts are becoming higher and higher, and the demand for hot-dip galvanizing is also increasing. Usually the thickness of electrogalvanized layer is 5 ~ 15μm, and the large roll galvanized wire layer is generally more than 35μm, or even up to 200μm. Hot dip galvanized coating ability is good, dense coating, no organic inclusions.
Post time: 26-12-22- Of course, the quality of any kind of product is also affected by the implementation of the specification of the manufacturer, if it is the welding screen manufacturers in the production of their own is not very high implementation of the specification, or in the production line of the procedure specification has declined, or there is no higher requirements on the production link.
- Wire mesh depend on own unique strengths are indispensable in building professional, reinforcing crack strengthening anti-cracking material, products with high degree of error is small, uniform mesh, mesh welding, accept ability is strong, not easy deformation, steel wire mesh in different fields have different called, people call it soft steel bar in bridge engineering construction.
Post time: 14-04-23- ① The diameter of galvanized iron wire for pulling should not be less than 4mm, and the diameter of galvanized iron wire for binding should not be less than 2.6mm.