- Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.
Post time: 19-04-23Stainless steel blade barbed rope material is produced according to stainless steel plate and stainless steel wire, as a whole have achieved the purpose of high quality anticorrosion. So how long can stainless steel blade thorn rope be used?
- The principle of hot dip galvanizing is simply that clean iron parts are immersed in a zinc bath through Flux wetting, so that the steel reacts with molten zinc to produce an alloyed skin film.
Abandoned barbed wire guardrail network will generally choose classification pick up, classification gathering pick up and other methods, better to promote the better use of the whole highway guardrail network, abandoned metal guardrail network is still common copper mesh profile.
- ① The diameter of galvanized iron wire for drawing shall not be less than 4mm, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm.
Post time: 09-08-22When large rolls of galvanized wire are used to bind and reinforce the goods, corresponding binding methods should be selected according to the fastening node conditions of the strengthened goods, such as opening binding, opening binding, insertion binding and so on. The insulation layer of semi-hard and soft insulation products shall be based on the diameter of the steel pipe and the size of the equipment. Large rolls of galvanized wire or glue are tied together with a width of 60mm. The binding interval of semi-hard insulating products shall not exceed 300 mm; The larger length of felt and cushion shall not exceed 200mm, and the number of belts shall not be less than 2.
The common weight standard of galvanized barbed rope is 25kg per coil, and the length of each coil varies from 220-250 meters according to the specifications of the barbed rope. And of course we all know that the heavier the disc the longer it is. But there is one point that is worth our attention, that is, the hollow inside the general larger disk is relatively small, and the hollow inside the lighter galvanized thorn rope is relatively large. The purpose of this is to reduce the number of bending of the thorn rope and make it easier and more beautiful when installing, on the other hand, it looks larger in appearance.
Post time: 12-12-22Hexagonal net in the landslide value is also quite high, many slopes through the baptism of the rain after this, there may be sediment flow and other disasters to the people’s property lead to a certain loss, with the existence of the hexagonal net, can fundamentally go up to solve the problem, sediment flow when it comes to it can implement effective protection, is the loss of many people to low. The hook mesh was installed on the hillside, still a nice view line. Under the irradiation of the sun, the metal material of the hexagonal net shines brightly, and its beautiful shape is combined, giving the mountain a kind of elegant feeling.
- The acceptance of cold-drawn low carbon steel wire shall be conducted according to the same production unit, the same raw material, the same diameter, and shall not exceed 30T for an inspection lot, and check the base material into the factory or out of the inspection statement. The inspection items for each inspection lot are appearance quality, diameter error, tensile test (including tensile strength and elongation) and repeated bending test.
The wire used for barbed wire is woven or welded with low carbon steel wire, medium carbon steel wire, high carbon steel wire, stainless steel wire and other materials. The production process includes: general braid, embossed braid and spot welding. If the material is steel wire, after equipment processing into a network, it is called wire mesh.
- Excellent anticorrosive makes its popularity in the feed, the net surface smooth and tidy, increased the look and feel, can be adornment effect, this characteristic makes it to show in the mining industry, due to high quality with low carbon materials as raw materials, to make it unique general iron mesh screen does not have flexibility, determine its plasticity in use process, It can be used for the deep processing manufacturing of hardware technology, the batch swing of complex wall body, underground leakage prevention and cracking prevention, light net body, so that this cost is much lower than the cost of iron screen, more can realize its economy and benefit.
There are three methods to detect the thickness of zinc layer of galvanized wire: weighing method, cross section microscopy method and magnetic method, among which the first two experiments will cause certain damage to galvanized wire, including the length of galvanized wire and the reduction of dosage. The general detection of galvanized wire galvanized layer is detected by magnetic method, which is also a more intuitive and convenient method. The standard of galvanized layer thickness is related to the wire diameter of galvanized wire. The larger the wire diameter of galvanized wire, the thicker the galvanized layer is. It is the thickness of galvanized layer and cast iron after centrifugal separation.
Post time: 19-09-22Barbed wire can be used to prevent livestock theft, for one thing, because the surface is covered with sharp spikes that make it difficult to get through the barbed wire. On the other hand, because livestock generally have the habit of collision, the use of barbed rope in the circle makes the livestock dare not rush to collision with the barbed rope, so as to save the user’s cost.
- Galvanized iron wire is divided into hot galvanized wire and cold galvanized wire (electric galvanized wire) is made of low carbon steel, after drawing molding, pickling rust removal, high temperature annealing, hot galvanized, cooling and other processes. Galvanized iron wire has good toughness and elasticity, zinc content can reach 300 grams/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. The products are widely used in construction, handicrafts, wire mesh, galvanized hook mesh, spackle mesh, highway fence, product packaging and daily civilian and other fields.
- Scope of use: Because the obtained coating is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In agriculture, such as pesticide irrigation, greenhouse and construction industry, such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, have been widely used in these years.
- In the processing of stainless steel barbed wire after cold galvanized or hot galvanized coating on the surface of the last zinc material, not only beautiful but also plays a good protective role.
Post time: 15-12-22
Post time: 13-12-22
Post time: 22-02-23
Post time: 16-03-23The large hexagonal mesh is called the stone cage net. Stone cage net before delivery, must be folded into a simple surface, packed compressed after delivery. Then put it in the right position to open, and then the block diameter suitable stone into the cage, the cover is tight, and then the various stone cage net and the adjacent stone cage net tied up.
1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.
A pet carrier can be used as an indoor or outdoor pet house. The dog cage is equipped with a fixed food basin and water fountain, and the foot plate pet cage rubber pad has bayonets on four sides to be splintered. It can be spliced, cut and disassembled according to the size of the cage. It is convenient and easy to clean. It can solve the problem of pinching the feet of the puppies in the ordinary cage and prevent the puppies from causing adverse reactions in the development. The dividers are breathable and comfortable, and can be used as heat shields for pets in summer. A puppy with small feet, no feet, no pinching.