In a large bowl, combine the flour, salt, and instant yeast. Pour in the warm water and stir until a shaggy dough forms. The consistency should be wet and sticky, which will help in developing the gluten structure.
An oil seal is designed to perform three major functions: to prevent lubricants from leaking outside the seal even under high pressure, to act as a barrier to retain the lubricating oil, and to prevent dirt and other contaminants from entering the unit.
There is a British Standard laid down for the control of synthetic rubbers. BS 3574 (1989) helps to determine shelf life – for instance, Nitrile (NBR) and Polyacrylic (ACM) are Group ‘B’ rubbers and have a 7-year life, whilst Silicone (VMQ) and Fluoroelastomers (Viton®) are Group ‘C’ rubbers and have a 10-year shelf life. PTFE and Leather do not come into this category but like the others should be kept in the original packing for as long as possible away from direct light, dust, and humidity. Ozone, which can also be produced by battery-driven forklift trucks has a very bad effect on synthetic rubbers. Finally, protect the sealing lip – DO NOT hang the seals on nails, wire etc.
An overview of the different standard types of oil seals and their main characteristics is shown below.


• ACM rubber or another
Rotary Wheel Of Auto Parts

ls1 spark plug wires.

Figure 5 explains the JTEKT seal numbering system.
Seal numbers consist of
(1) the seal type code,
(2) the spring code,
(3) the lip type code,
(4) the dimensional numbers, and
(5) the special type code,
and Table 6 shows examples of each of these codes/numbers.
Seals are essential to protecting the bearings of any rotating shaft assembly -They prevent contaminants such as dirt, dust and water, while also preserving the system’s lubricant.