- Correction is the hot galvanized wire or cold galvanized wire secondary treatment, the surface after correction is smooth and shiny, and the tensile strength is stronger, so that it is not easy to break. Now it is usually used for screen industry will be changed, which can improve the quality. In addition, clothes rack, communication, high voltage line will be changed to prevent breakage.
- There are many blade specifications, first of all there are three types: spiral type, straight line, spiral cross type. Different units, the strength of the protection of different rope models. The blade barbed wire is mainly made of low carbon steel wire and aluminum magnesium alloy wire by spraying and welding. The blade material of the blade barbed wire is attached to the core wire made of stainless steel wire with professional mechanical strength, so the blade barbed wire has the advantages of good strength and aging resistance.
Because zinc layer corrosion resistance, can be applied to all kinds of environment, use is also very convenient, has been more popular hardware products. Galvanized iron wire should pay special attention to the acyl washing, to slowly put into the container, to prevent acid sputtering on the body, and prohibit the water into the water, so that it is easy to let the acid out, to learn to handle gently, stacking should also be firm and neat. It can be widely used in architecture, handicrafts and other daily civilian applications.
- ③ Galvanized iron wire shall not be damaged when it is tightened.
The appearance quality of cold-drawn low carbon steel wire in each inspection lot shall be all visually inspected. The appearance of steel wire shall not have cracks, burrs, corrosion and mechanical damage affecting mechanical function. Cold-drawn low carbon steel wire with unqualified appearance can be used in engineering after treatment and inspection.
Post time: 19-05-22- The small homogeneous particles with large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles will cause explosion. Coating with activated carbon to remove surfactant, or filtering to make the foam less stable, are effective measures. Other measures should also be taken to reduce the amount of surfactant brought in to Z. The speed of electroplating can be significantly reduced by the addition of organic matter. Although the chemical formulation is conducive to high deposition rate, but the organic matter with the coating thickness can not meet the requirements, so activated carbon can be used to treat the tank liquid.
- Three points should be selected before installation, which are the highest point (lowest) and the side line on both sides. The number of thorn rope column is good. When installing, it can be installed gradually according to the hook arrangement of thorn rope column.
Hexagonal mesh is also known as twisting mesh, thermal insulation net, soft edge net. Material: low carbon steel wire, stainless steel wire, PVC wire, copper wire knitting: straight twist, reverse twist, two-way twist, first after plating, first plating after knitting, and hot dip galvanized, zinc aluminum alloy, galvanizing, PVC coated, etc. Features: Solid structure, flat surface, with good corrosion resistance, oxidation resistance and other characteristics. Uses: Used for raising chickens, ducks, geese, rabbits and zoo fences, mechanical equipment protection, highway guardrail, etc.
- In the process of composite plating, it is necessary to stir the plating solution to obtain the composite coating in which the particles dispersed in the matrix metal. Stirring methods include mechanical stirring, air stirring, ultrasonic stirring, bath circulation, etc. In the process of production, the acid activation solution can remove the corrosion products and oxide film on the surface of low carbon steel wire without excessive corrosion on the matrix. Galvanized wire can be used zincate galvanized or chloride galvanized and other processes, appropriate additives should be used to obtain the coating required by the standards of low carbon steel wire.
Post time: 11-07-22- 2, can quickly let the dog develop home habits, let it learn to wait for the owner to take it out, prevent it from making the home dirty, dirty its nest.
- Wire mesh depend on own unique strengths are indispensable in building professional, reinforcing crack strengthening anti-cracking material, products with high degree of error is small, uniform mesh, mesh welding, accept ability is strong, not easy deformation, steel wire mesh in different fields have different called, people call it soft steel bar in bridge engineering construction.
After proper heat treatment or cold drawing hardening, high carbon steel wire has high strength and hardness, high elastic limit and fatigue limit (especially notched fatigue limit), cutting function is acceptable, but welding function and cold plastic deformation ability is poor.
Large coil galvanized wire in the zinc immersion distance debugging, keep the original speed unchanged, according to t= KD to determine the zinc immersion time (1), where: t is the zinc immersion time is constant, take 4-7D is the diameter of steel wire mm, and then estimate the zinc immersion distance. By adjusting the zinc dip distance, the zinc dip time of steel wire of various specifications can be shortened by 5s on average. In this way, the zinc consumption per ton of steel wire decreases from 61kg to 59.4kg.
Post time: 24-10-225, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.
Post time: 07-11-22The entire steel surface is protected, and the melted zinc is easily coated evenly, whether in the interior of the pipe fitting in a depression, or in any other corner where the coating is difficult to access. The hardness of galvanized coating is greater than that of steel. The Eta layer of the upper layer of Z is only 70 DPN hardness, so it is easy to be dented by collisions. However, the hardness values of the lower layer of Zeta layer and delta layer are 179 and 211 DPN respectively, which are higher than that of the iron material of 159 DPN. Therefore, its impact resistance and wear resistance are quite good.
- Once you find that the beginning of it has deformation, rust or broken problems must be timely correction. Generally speaking, the blade barbed rope will not be damaged simply, but it cannot be ensured that it will not happen. Because the local place where the blade barbed rope is required is generally outdoors, the probability of presenting an incident will be greatly increased. For example, in the plantation under the hillside, the blade barbed rope was damaged and deformed by stones rolling down the mountain, which requires manual correction in time, otherwise the deformed blade barbed rope will not only affect the beauty, but also lay hidden dangers for safety.
Reduce the impact of the project on the environment, protect the slope protection area of land, maintain the rock can be fully strong, slope protection hook flower net through artificial planting grass planting, the implementation of green function. Suitable for any complex terrain, at the same time, does not destroy the original landform, the product is mesh distribution, visual interference, convenient for artificial afforestation, conducive to the environment, engineering and environment integration system flexibility.
- D, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.
- 2. When the weather is too dry and humid, remember to blow dry the cage or move it to a place with heating to prevent dry crack damage.
In our daily life, what we can bend with our hands is basically galvanized iron wire, not steel wire. It has a high zinc content, which ensures excellent toughness and resilience, as well as ultra-high corrosion resistance, which can be maintained in outdoor environments for decades. There are many practical galvanized iron wire, such as strong reliability, galvanized layer and iron together, forming a special metallurgical structure, in the use and transportation process, can ensure that it will not be mechanical damage.
In the calculation process of 12*14 specifications of barbed rope, it can not be calculated according to the above calculation formula, because first of all, two specifications of raw materials are used, the thinner the wire diameter, the higher the processing cost. Generally speaking, a kilogram of 12*14 barbed rope can reach about 7.5 meters, and the ratio of warp wire to barbed rope cannot be calculated according to the traditional ratio of 7 to 3. The specific use of how much wire and silk need to go through a series of professional measurement but also increase the loss of raw materials and other factors to calculate. Thorn rope factory will also according to customer needs to calculate the reasonable amount of customer use.
The material of the blade can be roughly divided into high quality steel wire, galvanized steel plate, stainless steel plate. The general technology used on the blade: hot dip galvanizing – stamping. The blade has the advantages of corrosion resistance, aging resistance, good weather resistance, easy installation, low price and so on. The use of blade rope: Blade rope has been widely used in military sites, prisons, government, banks, residences, private homes, villas, doors and Windows, roads, railway fences and border lines, etc., to ensure safety. Most prisons basically use razor blades.
- Stainless steel barbed rope is in the material aspect of protection so durability is also better, these two products are known for long service life, but is high in price.
- The surface of the galvanized wire deposition layer before galvanized to remove the surface film layer, surface inclusion and other defects to the local, can be found and treated by conventional technology. Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless.
The wire mesh is composed of low carbon steel wire or medium carbon steel wire, high carbon steel wire or stainless steel wire. There are two kinds of manufacturing technology of steel wire mesh, one is the weaving method, the other is the welding connection, the formation of grid.