Friction modifiers: Friction modifiers help reduce friction when your engine is operating under high temperatures and with heavy loads. This additive can also help you maximize your fuel efficiency.
Figure 5: Shaft surface with and without lead marks
An oil seal consists of:
NBR, also known as nitrile rubber or nitrile, is the most popular material for an oil seal because of its good resistance to many oils and greases, such as mineral grease and hydraulic oil. Depending on their composition, synthetic oils and greases, such as those based on glycol, can damage NBR rubber materials. Depending on the amount of glycol, a PTFE lip seal may be the best choice. NBR is also unable to cope with contact with acids and solvents. The rubber is suitable for oil and grease at temperatures from -35 °C to 100 °C.
6. AMOUNT OF LUBRICANT: Seals perform better when lubricated but some machines will go through some dry spells. When this occurs using a leather or PTFE seal will be more beneficial as those type of seals can operate with less lubrication.
Samples Submission :21-28 days with existing toolings.
To act as a barrier and prevent dirt, contamination and other external entities from entering the system containing the lubricating oil.
Oil seals, also referred to as shaft seals, are widely used to prevent the leakage of medium (such as oils and grease) along a rotating shaft. This leak prevention is primarily achieved by the sealing element which can be made from a wide range of materials that are chosen according to each application. They are commonly used in gearboxes, hydraulic cylinders, and related components.
Other important factors are ensuring the hardness and roughness of the shaft are correct. A shaft hardness of HRC 45 is recommended for a rubber sealing lip, with a roughness of Ra 0.4-0.8. A higher shaft hardness of HRC 60 and shaft roughness of Ra 0.1-0.4 is recommended for a PTFE lip.
Viton®
High level of chemical resistance
High temperature resistance