Post time: 03-04-23Galvanized steel pipe is divided into hot dip galvanized and electric galvanized. The layer of hot dip galvanized is thick, the cost of electric galvanized is low, and the surface is not very smooth. Used for steel blowing oxygen pipe, generally with small diameter welded steel pipe, specifications from 3/8-2 inches of eight. Made of 08, 10, 15, 20 or 195-Q235 steel strip, in order to prevent corrosion, some should be aluminized.
- The positive and negative twisting of barbed rope is less than 3 cents per meter, and the corresponding 12 hot-dip galvanized barbed rope is 50 cents per meter. No matter from the service life, tensile strength, rust prevention effect is no worse than 12 iron wire
- Whether the wire rope is chosen correctly or not directly affects the service life of the rope and causes the structural deformation, fracture and unexpected failure of the rope. Therefore, the selection principle is as follows: when the progress of unguided heavy objects is made once or repeatedly at a larger height, the non-rotating wire rope is selected:
- Since nose touching is an important part of dogs’ social behavior, humans can use this to train them. Experts say that if owners touch their dogs’ noses often when they are young, they will grow up to have softer personalities and be far less likely to hurt people.
Post time: 28-09-222. Check the stabbing rope of the blade on time
- 2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.
The characteristics of large volume galvanized wire is smooth and bright surface, but wet will affect the brightness of galvanized wire, so we must pay attention to avoid humidity when storing, can support a shelf on the ground, so that galvanized wire and the ground isolation, so that it will not be affected by the surface moisture, there is to pay attention to the change of weather, to avoid galvanized wire rain. Galvanized wire has good toughness and elasticity, the amount of zinc can reach 300 g/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance.
3cm electric welding net refers to the square hole net of 3cm mesh, galvanized net, impregnated plastic wire mesh, metal mesh, screen. Wide 0.914 m, 1.02 m, 1.2 m, 1.5 m, 1.8 m, length of each volume in 18 to 30 m, welded wire mesh is a wire drawing, wire with advanced welding equipment on the line of welding and become, can be cold zinc, hot dipped galvanized after welding, jinsu anticorrosive processing, also can use the black wire or change wire drawing, galvanized wire, stainless steel wire welding forming, The electric welding mesh is firm, the mesh surface is smooth, is widely used in construction, breeding, isolation, handicraft manufacturing, filtration, mechanical protection, animal fencing and other aspects, according to the demand can be customized electric welding mesh coil, can also be cut into electric welding mesh.
- In order to ensure the electrical conductivity of steel wire, manufacturers need to follow a number of standards and regulations. For example, in the galvanizing treatment of steel wire, the international standard ISO 1461 should be followed to ensure uniform zinc layer thickness and surface gloss. In wire drawing processing, excessive stretching should be avoided so as not to deform the wire or lose its mechanical properties.
- (3) For some use of special paint spraying should be baked, of course, depending on the size of the area, small can be placed in the oven, large can only be dried first, and then to dry parts for processing, lock baking, if other circumstances can only use high temperature tools bit by bit baking. The products that can be baked in the oven should be leveled at room temperature for 15 to 30 minutes, baked at a low temperature of 60 degrees Celsius for half an hour, and then baked at the reserved baking temperature for one and a half hours, and then cooled down.
Post time: 15-11-22- The diameter of welded mesh wire for external walls is generally 2.2-ф4.0, and the mesh is generally 25-50.
Spring steel wire with high carbon quality carbon structural steel or carbon tool steel wire rod production, according to the use of spring strict control of its chemical composition, gas content and non-metallic inclusions. In order to reduce the appearance defect and decarbonization layer, the billet of consumption rod should stop the appearance grinding, and if necessary, stop the peeling.
Post time: 05-05-22The type of barbed rope is mainly reflected in the specification of the wire diameter, the thicker the diameter of the barbed rope produced is shorter, at the same time, the price is cheaper, mainly because the production efficiency is relatively high, because the price of the barbed rope is calculated according to the weight when it is sold. On the contrary, the finer the diameter of the wire, the longer the price is higher.
Post time: 13-02-23
Post time: 18-11-22- 3. Straightening and cutting: straighten and cut the cold galvanized wire after drying to reach the set size and length.
The characteristics of this kind of small animal cage, is small, light, easy to carry, but also easy to clean care. For small animal cages, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violent”, or the cage under the “destruction” will occur welding or plastic crack off.
Post time: 09-03-23The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.
Post time: 26-05-23Hexagonal mesh is made of galvanized iron wire woven by automatic mesh machine, mesh into regular hexagonal shape, mesh standard, beautiful, mesh size can be customized according to customer requirements, usually 27mm,20mm, 13mm, wire diameter from 0.40mm to 1.20mm, to meet the requirements of different customers.
One: according to the color of the spray blade thorn rope, its price is higher than the ordinary blade thorn rope 2000-2200 yuan, but the price ratio of the spray blade thorn rope is much higher.
The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.