- B. When the thickness of the plating is greater than 4 mm, the zinc adhesion should not be less than 610g/m, that is, the average thickness of the zinc layer should not be less than 86 microns.
Post time: 27-09-22- Barbed rope manufacturers specializing in galvanized barbed rope, hot dip galvanized barbed rope, blade barbed rope, stainless steel barbed rope, plastic coated barbed rope, positive and negative twisted barbed rope production for ten years.
The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.
- The wire after the first plating, its strength limit is also higher than the first plating, plated zinc and then made of wire not only toughness and high strength. There is a lower figure in the strength limit of galvanized iron wire because of the quality of zinc, because the strength of zinc technology is several times smaller than the wire itself. It is difficult to hot-dip galvanize drawn wires, and it is impossible for finer and very fine wires to be coated with the desired thickness of smooth zinc.
Galvanized wire mesh is divided into hot dip galvanized wire mesh and cold galvanized wire mesh. Galvanized steel wire net selects the high quality low carbon steel wire, iron wire factory made by precision of automation machinery welding technology processing, smooth surface, firm structure, integrity is strong, even if the local cutting of galvanized steel wire net, or local also under pressure from loose phenomenon, after molding, wire mesh galvanized corrosion resistance good, has the advantage that the general steel mesh does not have.
Now it is more used in the binding of the construction industry. Compared with ordinary wire, it is also softer and has better luster. Use in daily life does not need to carry out maintenance and maintenance, saving a lot of time, but also save the cost of maintenance and maintenance. Annealed wire has good stability, good corrosion resistance, greatly prolonging the service life. There are many kinds, which can be selected according to different uses. The device for making annealed wire is simple, and the utilization rate of the device is improved. The material properties of annealed wire can meet different processing needs.
We must have a certain understanding of the hexagonal net, we are swayed by the beautiful shape of the hexagonal net, not only the shape of the hexagonal net is very beautiful, in fact, the practical value of survival is very high. Hexagonal mesh of all kinds of guardrail, the value of the highway is more prominent, it is not only used in a variety of roads, in a variety of sports ball venues and landslides try to take care of, but also to reach a very close utility.
Post time: 29-01-23- In use, it can be well used in the annealing process to control its degree of hardness, mainly used in the construction industry for binding silk and tying. Its use is certainly not limited to arts and crafts. It is also widely used in the construction industry. Earlier woven lanterns were made of wire, and inside were placed suitable candles, which were hung in front of the door. It was very beautiful to go up at night.
With the improvement of people’s living standard, pet raising is becoming more and more common. Pets also need a comfortable environment, so pet cage is an ideal choice for pet raising. Dogs are loyal friends of human beings. They will accompany you all your life and protect you until you die. Raising small animals can bring comfort to lonely old people; Patients who receive visits from animals can improve their depressed moods and even relieve pain. Families with pets add joy and cohesion; Companion animals usually form familial bonds with their owners.
- Large aperture hexagonal net is widely used in mountain, embankment protection, railway and highway isolation barrier, river channel management, soil consolidation berm, water conservancy engineering construction, rivers, DAMS and seawall anti-erosion protection and reservoir river interception, animal husbandry, grassland isolation guardrail, etc.
- In use, it can be well used to control its soft and hard degree in the annealing process, mainly used in the construction industry as a binding wire and binding line. Of course, its use is not limited to arts and crafts, but also widely used in the construction industry. Earlier woven lanterns were made of iron wire with appropriate candles placed inside. People hung them in front of their doors and looked very beautiful at night.
Post time: 02-11-22- Welding net material has black wire, galvanized wire, wire drawing. Mesh has 1 inch, 2/1 inch, 3/1 inch, 4/1 inch, 4/3 inch, 8/5 inch, etc. Different materials, different mesh, used in different places. Therefore, welding net is an indispensable building material in construction industry.
Some raw materials in the production of unstable processing, the wire itself will exist burr, surface small pits and other local defects. Galvanized steel in galvanized, generally should pay attention to the galvanized layer protection time of galvanized wire, and the thickness of galvanized layer has a great relationship. Generally speaking, when the main gas is relatively dry and used indoors, the galvanized layer thickness of galvanized wires is only 6-12μm, and under relatively harsh conditions, the galvanized layer thickness of galvanized wires needs 20μm, and can be predicted to reach 50μm.
And high quality data and production cost and production conditions are bound, so some welding screen manufacturers did not meet the requirements of this aspect, natural in this case there is no way to improve product strength. In addition to data, and produce process, even if again good data, but the factory did not meet the requirements of production process in welding, also can form the product under the high pressure welding, so it is also a kind of strength on the decline, process conditions of different manufacturers also have very big difference, so it formed a shopping mall on the above products are differences of strength.
The vertical distance between the lower edge of the Nestor roller cage and the upper edge of the reinforced concrete protective fence is 0.05m. Longitudinal reinforcement adopts hot-dip galvanized netting, double-twist weaving process, barbed wire 2.2mm, main line 2.5mm, netting joint card adopts galvanized steel plate stamping or Q235 carbon steel plate stamping for galvanized.
Post time: 20-02-23Galvanized welding net is currently a large use of galvanized wire drawing products, galvanized welding net is divided into cold galvanized welding net and hot galvanized welding net. The price of cold galvanized welding net is cheaper than that of hot galvanized welding net, and the anti-corrosion performance is worse. Production process standard for cold galvanized electric welding mesh. The selection of galvanized electric welding net uses Q195 low-carbon metal wire, the wire rod is drawn by wire drawing machine.
Stainless steel blade barbed rope production process is basically similar to galvanized blade barbed rope production process, usually according to the mold to determine the size of the blade.
- The material of wire mesh can choose galvanized wire, stainless steel wire, copper wire, coated wire, lacquer wire, etc., different materials are used in different fields, such as construction, culture, decoration, etc.
- For example, the following circumstances may lead to rust of 304 stainless steel pet cage:
The amount of zinc on the surface of high zinc barbed rope is about 5 times that of general zinc barbed rope, thus greatly prolonging the time of rust resistance. In the appearance of the two products are silver white and metal texture is better, for the distinction between the two products is more difficult to distinguish if it is a layman, but for long-term work of professionals can be separated from the two at a glance.
If the coating roughness is not caused by the above reasons, it may be caused by impurities in the plating solution. Can take a small amount of electroplating solution, filtration test, and then take a small amount of electroplating solution, with zinc powder treatment after the test, check the problem is solid particles or copper, lead and other foreign metal impurities caused by. One by one, it’s not hard to find the cause of the problem. Galvanized iron wire coating blister, poor adhesion.
Post time: 03-11-22Hot dip galvanizing is dipped in zinc liquid melted by heating, with fast production speed and thick but uneven coating. The market allows a low thickness of 45 microns and a high of more than 300 microns. The color is dark, the consumption of zinc metal is much, the formation of infiltration layer with the matrix metal, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can be maintained for decades. Application range of hot dip galvanizing: because the coating is thicker, hot dip galvanizing has better protective performance than electric galvanizing, so it is an important protective coating for iron and steel parts in harsh working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, power transmission, shipbuilding and other industries, in the field of agriculture such as sprinkler irrigation, greenhouse and construction industry such as water and gas transmission, wire casing, scaffolding, Bridges, highway guardrail and other aspects, has been widely used.