Recognizing and avoiding common installation mistakes is key to the longevity and effectiveness of oil seals. Here are some frequent errors to watch for:
- 5. Automotive Industry Molded gaskets are used in the automotive industry to seal engine blocks, transmission cases, and other components to prevent leaks and ensure proper operation.
- 1. Turn off your car and disconnect the battery to prevent any electrical shock.
- The Unsung Hero of Industry The Small Rubber Gasket
Garter springs are generally used when the lubricant is oil, as it provides the necessary downward force to maintain a tight seal. However, when grease is the lubricant, garter springs can often be eliminated. Due to its low viscosity, grease doesn’t require as much downward force to maintain an effective seal.
The simplest way is to know either the preferred manufacturers part number, the overall sizes of shaft diameter, housing diameter and bore depth, or use our brochure to establish the M Barnwell Services ordering reference. Many of the old traditional names of seal manufacturers have either changed or disappeared in this age of “acquisitions”. If no longer available, we will advise you and offer a suitable alternative seal, from stock whenever possible. If your concern is getting the right seals for the job, you will need to know something about the application as well as the overall sizes. If you have any doubts – contact us, we will help in your seal selection.
14.2 Oil-Seal Requirements
Rubber oil seals with a rubber fabric outer case
Indeed, when installing this oil seal, the oil sump must be installed using silicone seal. Removal of the old seal and oil sump is necessary, otherwise the oil seal cannot be fitted properly either. If these steps are not followed, leakage is inevitable.
1. The oil seal consists of a metal ring as the inner skeleton which provides the structural stability to the oil seal.

Also known as a Rotary Shaft Seal, Shaft Seal, Lip Seal, Elastomeric Lip Seal or any variation of these. It is a simple device for excluding dust, dirt, water or any other contaminant whilst retaining lubricant in rotary shaft equipment. Generally, it has been developed as a means of protecting the bearings of rotating shafts.
The construction of an oil seal is a testament to meticulous engineering. Each oil seal primarily comprises two core components: the sealing element and the metal case. The collaboration of these parts brings about the seal’s functionality and effectiveness. A garter spring may also be included as an available feature, providing an extra layer of operational support.