- The reason for the bridge reinforcement is that the bridge durability function is poor and aging, through the steel wire mesh reinforcement, can prolong the service life of the bridge, to avoid the bridge cracks, collapse and other phenomena, steel wire mesh in the bridge reinforcement anti-crack engineering can play an obvious effect, improve the construction speed of the project, enhance the concrete anti-crack function, sum up the economic benefits.
- If the connection near the installation is not completely aligned, then the installation has been aligned, and then the rest of the attachment installation, it will be relatively simple, and then install the blade thorn rope, installation of blade thorn rope must be the blade thorn rope with a clip card below the guardrail. And this will not damage the purse Seine, after the installation of the accessories, the guardrail is also equal to the installation, and then check the fixing of the screws, to determine that there is no problem after.
Post time: 21-07-22- Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.
The size of the galvanized layer of galvanized iron wire is related to the anti-corrosion ability and application effect of galvanized wire. The thickness of the galvanized layer of the general standard galvanized wire products should be tested after the product is formed. There are three specific test methods. Weighing method and cross section microscopy method are destructive experimental methods, and magnetic method is a relatively rigorous non-destructive method, but the measurement steps and requirements are relatively high, so they are rarely used in specific applications. The first two methods are intuitive and common methods.
Post time: 18-04-23Usually according to the general people, the blade barbed rope is the guardrail, widely used in garden apartments, military bases, private residential areas, government machinery where there is a fence, generally used blade barbed rope. The biggest advantage of the blade is that the protective effect is good, and the installation and maintenance is very convenient, strong isolation ability, good resistance effect, etc.
Hot-dip galvanized wire is widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transmission, shipbuilding and other industries. It has been widely used in recent years in agricultural fields such as agricultural medicine sprinkler irrigation, greenhouse and construction industry such as water and gas transmission, wire casing, scaffolding, Bridges, highway guardrail and so on.
4. Keep the rinse water clean after pickling the steel wire
- If you want to know how many meters a kilogram of barbed rope, you also need to know what type of barbed rope is, because the different type will directly affect its weight.
Post time: 28-04-22Features: Strong flexibility, good plasticity, a wide range of uses process: selection of high-quality low-carbon raw materials, after drawing, annealing processing, soft and strong tensile resistance. The finished product is coated with anti-rust oil, not easy to rust, can be bundled according to customer requirements, each bundle is 1-50kg, can also be made into U wire, broken wire, etc., plastic inside and linen outside packaging, mainly used for binding wire, construction wire, etc.
The use of electric welding mesh is very widely, but also used in different industries, different places, many times the name is named because of the use or use, so the use of electric welding mesh is doomed to a variety of different names. Can be called row welding mesh, or zinc plating welding mesh or galvanized welding mesh. There’s also the outer wall wire, which is just used for insulation, usually placed on the outside of the wall, to reduce heat emission.
Post time: 23-12-22Galvanized wire coating rough, passivation film is not bright, bath temperature is too high. If the cathode current density is too high, zinc content in the bath is too high or sodium hydroxide and DPE content is too low; Electroplating solution with solid particles or excessive foreign metal impurities, will lead to such problems. Solution: If the large roll galvanized wire to the above coating is rough, there may be solid particles in the plating solution. If the roughness of the part is severe, the current density may be too high.
Post time: 08-08-22The guide frame of spray hook net wholesale is composed of guide beam and park core pile, their interval distance is about 3 meters, the spacing of guide beam should be about 1 cm higher than the wall. When installing the guide beam, its position should be far away from the net, and the surround-pile should not be expanded, which will make the surround-pile sink or change its shape.
- The tensile strength of steel wire is high and the hardness is high. In the flattening process, the longitudinal movement resistance of steel wire per unit volume increases and the elongation decreases. The steel wire unit volume will move to the lateral resistance smaller, the width of the increase. On the contrary, the wire is easy to extend lengthwise, and its width decreases. This is the production of high steel wire hardness is easy to wide, small hardness, easy to stretch out of wide reasons. If the tensile strength deviation of steel wire is large, the hardness uniformity of steel wire strip is poor, the width difference of the billet rolled into large, will seriously affect the quality of the billet.
Wet air in rain and snow climate, steel mesh sheet exposed, easy to rust, to avoid affecting the use of steel mesh, it is necessary to carry out simple rust prevention treatment, of course, slight rust float will not affect the use of steel mesh. Common network site storage, rainy days, heavy snow, rainy days and rainy days, how to better save the steel mesh, this is a lot of friends need to consider.
3. The structure of the dog cage should be reasonable
- Three is to do a good job of galvanized silk product production site clean and tidy, in accordance with the scientific method of operation to operate the production, the operator should wear the required dress. If it is hot dip galvanized wire products, we must do a good job of passivation treatment, will be able to effectively prevent discoloration, prolong the method of discoloration, can solve the problem of discoloration.
Post time: 17-05-22- Packing: 25KG/ bale, plastic inside and woven outside.
Zinc dipping time should be adjusted according to the thickness of wire diameter. The method of adjustment is to use the lead screw above the zinc pot, the length of the distance to the ceramic sinking roller. Thick wire diameter zinc dipping time should be long, fine wire diameter zinc dipping time should be short, zinc dipping length is in the range of 2~3.5m, which is also to reduce the zinc consumption of steel wire, is an aspect of maintaining the uniformity of zinc layer.
- The zinc layer on the galvanized wire has good ductility, can be cold blanking, rolling, bending and other molding without damage to the zinc layer. The zinc layer of galvanized wire with thick zinc layer has fine crystallinity, uniform and no void, and good corrosion resistance. The zinc layer obtained by electrogalvanizing is very pure and corrodes slowly in the gas, liquid and fog of acid and alkali, which can effectively protect the steel matrix. Galvanized layer can also be chromate passivation into a variety of colors, beautiful and generous, with good decoration.
Bird cage placement and attention
Because of the high carbon content, simple cracks occur during water quenching, so double liquid quenching (water quenching + oil cooling) is mostly used, and oil quenching is mostly used for small cross section parts. This type of steel is generally used after quenching by medium temperature tempering or normalizing or in the surface quenching state. Mainly used for manufacturing spring and wear-resistant parts.